thoughtsfert.blogg.se - Usb image tool recovery

#Usb image tool recovery license key#
#Usb image tool recovery zip file#
#Usb image tool recovery for windows 10#
#Usb image tool recovery windows 10#

Go to Troubleshoot > Advanced Options: UEFI Firmware Settings. Or, from Windows, hold the Shift key while selecting Restart.

When the Dell logo appears, tap F2 on the keyboard several times to open the UEFI menu.

Turn on or restart the computer that you are repairing.

When the recovery process is finished, follow the instructions to reenable Secure Boot. To give your computer permission to start up with the Dell Recovery & Restore USB drive, Secure Boot must be disabled temporarily.

#Usb image tool recovery windows 10#

Note: Windows 10 and Windows 8.1 includes a security feature that is called Secure Boot that ensure your computer starts up with trusted software only.

#Usb image tool recovery for windows 10#

Step 2: Start, or boot, the nonworking computer from the Dell Recovery & Restore USB drive For Windows 10 and Windows 8.1

When the process is completed, you will see an "Operation done" message.

If a dialog box about formatting a disk appears, please ignore the message and close it by clicking the X in the upper-right corner.

Click Start to transfer the Dell Recovery & Restore software on to your USB.

If it is not detected, click the Refresh icon next to the drop-down box. The software should detect the USB drive.

On the Dell Recovery & Restore application window, select the USB drive as the media that you would like to use.

Connect a 16 GB or larger USB drive to any available USB port.

On your desktop, click the Dell Key Creator icon to open the application.

Open Dell Recovery & Restore to transfer the software to your USB drive

When the installation wizard is complete, click Finish.

On the Dell Recovery & Restore installation wizard, click Next and then click Install.

The Dell Recovery & Restore installation wizard will appear on the screen.

Click or run the Dell Direct Key or setup.exe file to launch the installer.

#Usb image tool recovery zip file#

zip file type and then attempt to extract the files. In this configuration, if a System Restore key is plugged into the front USB port, it will always work normally.Note: If the file will not extract correctly, the download may be corrupted or does not have the correct file extension.

#Usb image tool recovery license key#

Then, make sure the USB extender cable for the front panel USB ports is plugged into the USB port directly above the Waves USB license key on the motherboard. ** Any users who wish to keep the Waves USB license key stored inside the S6L Control Surface should plug the key into the bottom left USB port on the S6L motherboard (this is the port closest to the meter bridge). The Waves USB license key can be connected to the external USB ports to avoid this issue in the future, or see the note and photo below about connecting the key internally. Reconnect the Waves USB key when the System Restore is finished.Power on the control surface while holding F10 on the USB keyboard to boot normally from the System Restore USB key.Remove the S6L Control Surface rear cover.Note that this conflict only occurs when the Waves USB license key has been installed directly to certain USB ports inside the S6L Control Surface. This problem is caused by a boot device conflict that occurs when both the VENUE System Restore USB key and a Waves USB license key are connected. "The restore image on this USB drive is not valid" error or "Invalid Partition Table" error occurs or a FreeDOS screen appears when attempting to boot the S6L Control Surface from a System Restore USB drive by holding F10 at startup. "The restore image on this USB drive is not valid" error or a FreeDOS screen appears when attempting S6L System Restore